Sometimes is needed modify the default value of a script. For example the ping. Below is explained how to do that with fixed or variable values.

Requirements:

• the host must be present in the section SCM > Network > Host.

Connect at the SGBox web interface on  SM > Configuration > Script

Click on New Script Test to create a new script.
Once the configuration window is opened, select the host on which you want to make the test and the frequency.
All the Retry parameter are explained in the first article: Create a new test script

Select Ping Report as test the probe that will execute the script.
As you can see the default Warning value is 10ms. Click on Modify in order to modify it.

There are two ways to modify the script:
1. Directly changing the reported value. In our example from 10 to 100 and click on ADD. Remember to put the Default flag and give a new name if you want to reuse it.

2. Using variables. You can set the variable WARNING and put your value in the right box. In this way you are able to change it without recreate the script. Remember to put the Default flag and give a new name if you want to reuse it.

Click on Save to apply your settings.

This section explains how to modify some test script’s arguments.

Requirements:

• At least one test script must be configured. Look at this section to create a test script

Connect to SGBox web interface and navigate to SCM > SM > View > Host.

The check’s results are shown. In our case the Frequency has been set to 1m (1 minute).

Select the scripts you want to change and set the new value in the top section. In our case we want to change the Frequency to 10m (10 minutes).

Click OK to confirm your changes.

This section explains how to verify the results of test scripts and evaluate the health of your network.

Requirements:

• At least one test script must be configured. Look at this section to create a test script

Connect to SGBox web interface.
SCM > SM > View.

Select Host.

The check’s results are shown. In our case the system is up and we can see also the response time.

These scripts are used to perform check and evaluate the health of your network. Below is explained how to configure a simple script that makes a ping to check if the machine is up or down.

Requirements:

• the host must be present in the section SCM > Network > Host.

Connect at the SGBox web interface.
SGBox > SM > Configuration

Select Script.

Click on New Script Test to create a new script.

Once you open the configuration window, select the host on which you want to make the test.

On section Email Alert select the user who should be notified when a problem occur.
In Frequency section, specify every how many minutes the check will be perform.
Below are some values to be set when the check fails:
For N times: set the number of times you want to retry the check before changes state.
Every N Seconds: specify every how many seconds the re-check will be perform.
Alert after N Failures: After these number of failures the state will be changed ( from OK to CRITICAL for example ).
Click on Next to go to the next step.

Select a Default Script from the list. In our case we will select Ping Report.
Select a Probe, that is the machine that will perform the check. If SGBox will run the test (as in our case): select SGBox. If you are in a distributed environment or MultiTenant environment and the collector will run the test: select the collector instead SGBox.
Click on Add button.

Click on Save button to finish.

We have configured the test script.